Suspect Asbestos-Containing Materials Checklist

Planning a remodel, repair or demolition? These are the building materials our inspectors look at during an asbestos survey. The list draws on EPA inspection guidance and known historical uses. Tap a section to see every material in it.

Before you start

  • A material on this list is not confirmed asbestos. The only way to know is to have it sampled and tested by a lab.
  • Age alone doesn’t rule asbestos in or out. Some materials installed after 1980 can still contain it, and the same product can differ from one installation to the next.
  • If a material might contain asbestos, leave it alone. Don’t sand, saw, scrape or drill it before it’s tested.
  • Vermiculite insulation: EPA advises treating it as if it contains asbestos and leaving it undisturbed. Testing can give misleading results depending on the method, so talk to an asbestos professional before you sample or remove it.
Walls, drywall and ceilings

drywall joint compound and taping mud; drywall and spray texture; popcorn (acoustic) ceiling texture; orange-peel, knockdown and skip-trowel texture; wall and ceiling plaster (skim, finish and base coats); lath-and-plaster; decorative and acoustical plaster; stucco and stucco finish coats; cementitious wall coatings; spackling and patching compounds; wallboard and cement board; fire-rated wall panels; acoustical ceiling tiles and suspended ceiling panels; ceiling tile adhesive; vinyl wall coverings and their adhesives; textured and specialty wall paints; spray-applied wall and ceiling insulation.

Flooring

9×9 and 12×12 vinyl floor tiles and other resilient tiles; asphalt floor tiles; vinyl sheet flooring; linoleum-type sheet flooring and backing; felt- and paper-backed flooring; underlayment and backing; black cutback adhesive (mastic) and other flooring mastics; carpet adhesive and backing; vinyl cove base and adhesive; floor leveling and patching compounds; cementitious floor toppings; specialty floor coatings; adhesives between multiple flooring layers.

Tile, bathrooms, kitchens and wet areas

tile setting mortar and thinset; tile mastic; grout; tile backing and cement backer board; shower wall backing; shower pan mortar beds; waterproofing membranes and mastics; tub, shower, sink and countertop caulking; countertop adhesives; fire-resistant countertop materials; older resilient countertop coverings. Each layer may need its own sample.

Insulation and fireproofing

pipe insulation, wrap and lagging; boiler, furnace and water heater insulation; steam line insulation; HVAC duct insulation and duct wrap; air-cell and corrugated pipe insulation; insulating cement; calcium silicate and magnesia insulation; insulation blocks, blankets and mats; spray- and trowel-applied fireproofing; structural steel fireproofing; fire-resistant insulation board; vermiculite insulation; certain older loose-fill insulation; firestop packing and sealants; fire-resistant cloth, rope and tape; high-temperature gaskets.

Roofing

asphalt shingles; roofing felt; built-up roofing membranes; roofing tar, mastics and adhesives; roof coatings; roof and base flashing; roof patching compounds and sealants; roof underlayment; asphalt waterproofing membranes; cementitious and corrugated asbestos-cement roofing panels; roofing insulation boards; roof penetration sealants.

Exterior

asbestos-cement (Transite) siding and shingles; cementitious siding panels; exterior cement board; exterior wall coatings; stucco systems; window glazing compound and putty; window and door caulking; expansion joint sealants; exterior and foundation waterproofing; asphalt damp-proofing; fire-resistant exterior panels; older siding adhesives.

Mechanical, plumbing and HVAC

pipe elbow, fitting and valve insulation; boiler, flange, pump and furnace gaskets; high-temperature packing; furnace refractory lining; HVAC vibration-isolation fabric and flexible duct connectors; duct sealing compounds; cooling tower components; heat-resistant equipment panels; asbestos-cement water and sewer pipes; pipe joint compounds; fire-rated mechanical penetrations.

Electrical and fire-rated components

wire and cable insulation; electrical panel backing and insulation boards; arc barriers; heat-resistant electrical cloth and paper; fire-rated doors, cores and partition boards; elevator brake linings and equipment panels; fire curtains and blankets; high-temperature appliance parts.

Adhesives, sealants and other products

construction, flooring, wall-covering, ceiling and asphalt-based adhesives; window putty and glazing compounds; caulking; expansion joint fillers; firestop and waterproofing sealants; specialty cementitious compounds; laboratory countertops and heat-resistant surfaces; older chalkboards; specialty acoustic panels; heat-resistant paper products.

Not sure what’s in your building?

We sample suspect materials and send them to an accredited lab, so you know what you’re working with before the project starts. A negative result covers the samples taken, so keep the lab report and ask whether other rooms or layers need sampling.

Call San Diego 858.433.3290 · Orange County 714.515.5095 · Bay Area 415.857.9443

Sources